- Tab Content
- Roberts_Clif's Activity
- About Me
- Friends
- Tab Content
-
Older Activity
-
05-14-2024, 08:11 AMRoberts_Clif replied to a thread Issue with Ender 3 pro when printting in General 3D Printing DiscussionIf you flashed your firmware then in order to figure out what went wrong you will need to post at least the configuration.h and configuration_Adj.h...1 replies | 1297 view(s)
-
05-11-2024, 08:34 AMRoberts_Clif replied to a thread How to make a custom Cura profile... in 3D Printing Slicer DiscussionTook a quick look using google found this hope it helps Here The code looks almost exactly like startup code on my Hictop 3DP11/12's. My...1 replies | 2456 view(s)
-
05-08-2024, 03:06 PMI know that the Extruder stepper motor will not move filament until the Hotend is up the temp. Though we need to determine if the stepper motor is...7 replies | 5837 view(s)
-
05-07-2024, 12:39 PMI 3D Printed this nozzle box I found on t https://www.printables.com/model/154769-nozzle-box This was a fun project an as you can see...7 replies | 5837 view(s)
-
05-06-2024, 05:48 PMI have a similar 3D Printer and had a block so bad that decided to replace everything. Throat w/PTFE throat Heater Block Nozzle 12/24volt...7 replies | 5837 view(s)
-
05-06-2024, 07:44 AMYes they are called a Sock Official Creality Ender 3 V2 Neo Silicone Sock7 replies | 5837 view(s)
-
05-05-2024, 09:40 AMHave no ideal what you mean by derugulated. However I have just had a similar problem after several hours of troubleshooting I have learned that...2 replies | 2220 view(s)
-
04-29-2024, 08:40 AMhello Use 210C for Nozzle and 55C for Bed temp with PLA+. ALWAYS use a raft1 replies | 3365 view(s)
About Roberts_Clif
Basic Information
About Roberts_Clif
- Location:
- Washington State, USA
- Occupation:
- Electroncis Tech / IT / Programmer
- Thingiverse:
- Roberts_Clif
Statistics
Total Posts
- Total Posts
- 1,151
- Posts Per Day
- 0.45
General Information
- Last Activity
- Today 08:07 AM
- Join Date
- 06-12-2017
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion