Hi, I am new to 3D printing and bought an anycubic vyper a few months ago. It has been working great, making really nice, clean prints. Today, however, it suddenly started printing horribly, making extremely stringy prints with lots of pock marks. I have not changed filament or any settings.

I've read that wet filament could cause problems like this, but my printer and filament have been in a closed room with a constantly-running dehumidifier this whole time, so the humidity has not changed and is never above 50%. I was using PLA+ but tried a role of regular PLA as well (was also stored in the same room) and it shows the same issues.

I tried printing a temperature tower and retraction distance tower (photos below), but both were awful at all temperatures and distances.

I'm really confused because nothing seems to have changed. I'm running the same filament in the same conditions on the same settings that I have been running. Any advice is appreciated. thanks.

A6509430.jpg
A6509431.jpg