Results 1 to 10 of 54
Thread: My useless 3d printed trinkets
Hybrid View
-
10-24-2022, 04:20 PM #1
- Join Date
- Jun 2022
- Location
- The great state of Texas
- Posts
- 151
Changed my mind on the pose and going with a different one. 4 to 5 days of printing but looking forward to it. First gun is printing now.
I'll have to see how the parts fit together. Also don't know the balance on the model. Might have to print a base for it later if it doesn't stand on its own.
I have had my printer for 3 months now and still learning. I have a long ways to go.
-
10-28-2022, 02:53 PM #2
- Join Date
- Jun 2022
- Location
- The great state of Texas
- Posts
- 151
Just a quick update. I thought I was almost done and printing the last piece.
But I just realized one of my leg models was messed up. When I was moving the pieces around for the posing I shifted one of the parts out of place. The bad part is its a 21 hour print.
Second, as I was playing with one of the pewpews I may have kind of broke it in half. I super glued it but still wiggly so have to reprint. An 8 -9 hour print.
So about half way there. The final model will be around 17 inches tall.
-
10-31-2022, 08:17 PM #3
- Join Date
- Jun 2022
- Location
- The great state of Texas
- Posts
- 151
Have to reprint my pewpews again. My fault for the last couple of prints for the pewpews.
Here are my failed or rejected prints.
I am hoping I can start gluing the model together tomorrow. So in a day or two I hope I can post a picture of the final model.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion