Results 1 to 4 of 4
Thread: Scanning to reverse engineer
Threaded View
-
08-21-2015, 02:24 PM #4
Hey Mike,
Autodesk Fusion 360 is not bad, it integrates a traditional CAD package with Tsplines, runs on Mac too, free for hobbyist,
I'll probably end up using 3dCoat ad ADF 360, maybe with a bit of Meshlab if the Einscan mesh is a little messy.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion